Leather Ultima

Leather sealant

We can effectively protect nearly all types of leather from water, dirt and stain formation thanks to modern high-performance particles. Appearance, color or feel will thereby not be reduced in any way. Leather is easy to maintain and remains breathable. Damage caused by discoloration or oil and coffee stains or other frequently occurring causes are things of the past. servFaces Leather Ultima ensures permanent protection with state-of-the-art high-performance particles! Leather Ultima creates a dirt, water and rain-repellent protective film on the leather. The high-performance particles are stable and work for up to 18 months!

Areas of application:

• Covered smooth leather
• Semi-aniline leather
• Open-pore smooth leather
• Suede leather
• PU-leather and split leather

Properties:

• Long-term protection
• UV-resistant
• Easy-to-clean 
• Water and dirt-repellent
• Breathable
• Simple application
• Colorless and transparent liquid
• Contains no Teflon, wax or silicone

Preparation: 

The leather must be thoroughly cleaned before sealing to remove all care and impregnating agents. Use Leather Cleaner for that. After cleaning, the leather must fully dry again.

Application:

The surface needs to be wetted all over to form a thin, smooth wet film on the leather. You can optionally run the product into the leather structure and leave to dry afterwards. Temporary darkening may occur always according to coating thickness.

Caution: Do not apply the product in direct sunlight and do not let it dry!

Curing time:

The product is fully effective after complete air curing. Curing can also be carried out using a fan heater if the leather is suitable for it. Thermal curing increases the effectiveness.

Follow-up treatment/Refreshment:

Should fading occur, you can refresh the leather as much as with the first application, unless the leather is heavily soiled.

Lifetime:

The lifetime is 12 - 24 months, always according to the substrate and surface stress.

Application temperature: +15°C to +40°C 

Consumption: 20 to 35 ml per m² (always according to the type of leather)

Weatherproof after: 4 to 6 hours at +20°C

Fully cured after: 12 hours

pH resistance: 9.8

Storage temperature: +10°C to +25°C 

Storage and shelf life: At least 12 months at ambient temperature in tightly sealed original container.

Caution: Protect the product from direct sunlight and freezing temperatures!

Note:

Emulsions and coating products need a certain period of time to bind to the surface and fully cure after application. Therefore, please check the curing time of individual products. Only this can guarantee that the product provides the desired benefits. Direct exposure of the surface to water or cleaning agents after application can significantly reduce the performance of the product properties.

General information about the product:

Factors such as preliminary cleaning, application temperature, curing time, etc., can influence the product's effectiveness and lifetime. Therefore, fluctuations of product properties cannot be excluded.

Container sizes:

Accessories:

Premium Applicator Sponge, applicator Puck MAXI, Premium Buffing Towels

Note after use:

Surfaces treated with sealers should principally always be cleaned as gently as possible to avoid damaging or even removing the product properties.  Avoid using strong cleaning agents with high pH or a high content of solvents. 

This product information should and can only be taken as non-binding advice. The manufacturer does not accept any liability whatsoever. Before use, make sure that the product is suitable for your particular application.